5
Figure 4 Power Connection Kit Assembly
Figure 6 Cradle Assembly
6.
Attach this assembled end
by sliding along cable
and connecting to plug.
8.
Tighten around power cable to
prevent slipping. Do this last.
1.
Assemble these 4 parts first.
Then slide onto Power Cable.
Do not Tighten.
7.
Connect the assembled kit to the
mating power connector plug
located on the housing cradle.
See
Figure 5
.
2.
Strip outer jacket of Power Cable
1/2". Strip the individual wires 3/8".
4.
Insert stripped wires to
Connector Plug. See
Detail A
for wiring configuration.
5
. Snap these two pieces together
tighten bracket over wires.
2
1
G
3
Detail A
Connector Plug
Position 1 - 24VAC/12VDC+
Position 2 - Not Used
Position 3 - 24VAC/12VDC-
Position 4 - Ground
Note: Cable Size: Outside diameter
between 4.2 mm
(0.167 in) & 9.5 mm (0.375 in)
3
. Slide stripped wires through harness.
Attach bracket with two
screws as shown. Do not tighten.
1.
3
.
4.
5
.
6.
8
.
7
.
5.7 Power Connections: External
1. Use the Power Connector Kit (included) to route the
power into the housing. See Figure 4, Steps 1-8 to
assemble Power Connection Kit .
2. See Detail A in Figure 4 for the wiring configuration.
5.8 Video Connection: External
5.9 Cradle Assembly
1. Position the housing vertically and replace the cradle
assembly by applying pressure onto the rear cap until
the retaining ring stops against the housing. DO NOT
OVER TIGHTEN. See Figure 6.
2. Tighten the retention Screw, making sure it is seated
into the rear cap groove.
3. Attach the housing to the appropriate mount or pan/tilt
using the instructions provided. According to the
orientation of the housing, the cradle assembly may need
to be rotated. To rotate the cradle assembly (while
mounted), grasp the rear handle and rotate to the
desired position. View the monitor while rotating.
Power Connector
Connect to Power
Connection Kit
Video BNC Jack
Connect Video cable
with Outdoor rated
BNC connector.
Mating
Figure 5 Video Connection
Retention screw
WARNING:
Only use the cables specified under
Cable Requirements for wiring of the video coax
connection.
1. Connect the video cable to the housing using an
appropriate outdoor rated BNC connector. See Figure
5
for location.
W W W
.
W A T E C C A M E R A S
.
C O M
3. Tighten Power Connection Kit (after assembly to
housing) around power cable to prevent slipping.
