4
Input Power Cord - North American
Cable Type:
SJTOW-A rated.
Cable Size:
Outside diameter between 4.2 mm
(0.167 in) & 9.5 mm (0.375 in).
Cable Shape:
Round.
Conductors:
3 conductor version and
2 conductor version.
Agency Rating:
UL/C.S.A., UL VW-1.
Environmental:
Outdoor rated.
Temperature Rating: 105° C.
Voltage Rating:
300 V.
Sources:
Belden 19506
Belden 19509
Northwire 573939.
Input Power Cord - European
Cable Type:
H05RN-F3G0.75 and
H05RN-F3G1.00.
Cable Size:
Outside diameter between 4.2 mm
(0.167 in) & 9.5 mm (0.375 in).
Cable Shape:
Round.
Conductors:
3 conductor version and
2 conductor version.
Agency Rating:
VDE.
Environmental:
Outdoor rated.
Sources:
Olflex 1600252
Olflex 1600253
Retention Screw
Rear Handle
Cradle Assembly
Washer
Spacer
Camera (not included)
1/4-20 x 1-1/4
Button Head Cap Screw
Figure 1 Removing Cradle Assembly
5.5 Camera Installation
With the cradle removed from the housing, follow all of the
steps below.
1. Place the camera/lens combination into the cradle
assembly.
1.1 Fixed Lens Cameras: Position the camera/lens 1 mm
(0.04-inch) away from the faceplate. The camera/lens is
secured to the cradle with a
1
⁄
4
-20 button head cap screw
(BHCS) and the appropriate plastic spacer (see Figure 2).
Figure 2 Mounting a Camera
Figure 3 Camera Video and Power Connections
5.4 Cradle Removal
1. To begin removing the cradle from the housing, lower
the retention screw completely on the bottom rear of
the housing. See Figure 1.
2. Remove the cradle by grasping the rear handle and
pulling the cradle assembly out of the housing. Be sure to
keep the edges of the end caps clean and free of
scratches.
1.2 Zoom Lens Cameras: Allow 3/16-inch (5 mm) clearance
from the front face of the lens to the front faceplate of the
cradle during the camera/lens assembly. This clearance
provides the necessary space for the lens to extend out-
ward when zooming. Secure the camera to the cradle with
the
1
⁄
4
-20 BHCS and appropriate plastic spacer.
BNC Video Connector
2 Power Connections
5.6 Power and Video Connections: Internal
1. Connect the 2 flying leads to the camera's power input.
Connect the BNC Video Connector to the Camera as
shown.
See Figure 3 for locations.
W W W
.
W A T E C C A M E R A S
.
C O M
