CONNECTION AND SETUP
5
2-2 To install on the second bracket
Connect the power connector and
data bus connector to the HDD.
When connecting the power cable,
make sure the cable is passed
through the power cable of DVD
writer if your DVR is equipped with
a DVD writer. This is to prevent the
HDD power cable from interfering
with the fan spinning.
Align the screw holes of the bracket
with the HDD’s screw holes. Make
sure the PCB side of the HDD is
facing up. Then, fasten the HDD to
the bracket.
Step3: Close the upper cover of the DVR, and fasten all the screws you loosened in
Step1.
For 4CH Model
Step1: Loose the screws on the upper cover and remove it from the DVR. Find the hard
disk bracket located on the DVR base.
Step2: Get a compatible hard disk, and connect it to the power connector and data bus
connector.
Step3: Make sure the PCB side is facing up, and place the hard
disk between the hard disk bracket on the DVR base as
shown below.
Make sure the other side of the hard disk is
contacted with the DVR base for heat conduction.
Summary of Contents for DVR8ENT3
Page 55: ...REMOTE OPERATION 49...
