Watchguard ALL-PACK1, User Manual

Page: 16 / 23

Central Station Setting
The system support Ademco Contact ID and SIA TCP/IP protocol
It's able to communicate alarms and events directly to the
Central Monitoring.
Configure reception of events on the CMS and specify the
encryption key if you intend to use encryption. The encryption
key may contain up to 32 HEX or 16 ASCII characters.
Enable "Connect on central station", and in the Protocol field,
select CONTACT ID or SIA Protocol, then enter the account
number of alarm panel, specify the central station tel number
or the primary and secondary IP address of the CMS.
In the event the alarm, the alarm system will call the preset phone
number, user can pick up the phone , monitor the site, and remotely
control system by entering below numbers.
Disarm the system, press ; 0
Arm the system in the away mode,
press ;
1
Turn on on site siren, press ; 7
Turn off on site siren, press ; 8
Monitor the site, press key; *
Press escape (#) or hang up to exit.
Phone Remote Control
8888 8888
00:01
+