13
The text message will read similar to:
“
ALERT Temp F, limit 34.0 F,
current 33.7 F
”.
If both Voice Call and Text Message are set to NO only the relay
will be activated during an alert.
The relay choice is used to trigger a switch that will perform an ac-
tion (See setting up a relay function on page 16), such as sound a
horn, turn on a fan, or turn on an irrigation system, it will not trigger
the modem to make a call.
Notify
-
The Notify mode sets a second threshold and will send
text messages to the same phone number(s) as programmed in the
Alert mode at a selected interval when the sensor value is between
the Limit threshold and the Notify threshold. When the Limit thresh-
old is reached, the unit will go into Alert Mode. If the sensor value
leaves the Notify threshold range in the other direction, an
“
All
Clear
”
text message will be sent marking the end of the Notify
mode.
Note:
The Notify mode will not make phone calls, only send a text
message regardless of the voice/text setting of the Alert mode.
The unit prompts for a time interval to be chosen. Using the up and
down arrow buttons choose 15 min, 30 min, 45 min, 60 min or OFF.
If OFF is chosen, no notification text messages will be sent and the
unit will only utilize the Limit threshold of the Alert mode, and the
display will toggle back to Setup mode.
Press SET to choose the interval or OFF. The display will toggle to
the threshold sensor value.
‘
Above
’
or
“
Below
’
is not editable and
will be the same as set in the Limit setup. Use the up and down ar-
row buttons to change the value and press SET to select a value.
The Limit and Notify thresholds cannot overlap. When a sensor val-
ue is selected the display will toggle back to Setup mode.
Run Mode
-
Used to start monitoring. This mode will show the cur-
rent sensor value. Verify the sensor value on the Cellular Alert is
equal to a known standard.
