Wassermann Polyquick 160-T120, User Manual

Page: 19 / 28

9 Troubleshooting
Fault Cause Solution
Polyquick 160-
T120 does not
heat Lid is open (p. 20,fig. 1)
Close lid against safety contact.
Temperatur-programme-
parameter is to low Adapt the parameters.
Preheating temperature
is to low Adapt the parameters.
Heater faulty Please contact our service department.
Pressure does
not increase in
chamber Lid seal O-ring faulty Check O-ring and replace if necessary.
Pressure regulator set to 0
(pressure gauge). Check pressure and adjust if necessary.
Lid not fully closed Close lid against safety contact or
contact faulty.
Thermal fuse off
or Thermal fuse faulty
Let the unit cool down and try again
Replace faulty fuse. Please contact our
service department.
Display blank Thermal fuse off
or Thermal fuse faulty
Let the unit cool down and try again
Replace faulty fuse. Please contact our
service department.
Touchscreen
malfunction Calibrate the touch display Switch on the unit. While the logo of
Wassermann appears please contact
the touch display two times.
Then you will reach the self-explanatory
touch panel-calibration*
(p. 20, fig. 2-3).
Touchscreen under pressure
Please contact our service department.
Screen protector damaged? Please contact our service department.
Unit does
nothing Blown fuse Check the two fuses seperately.
Disconnect the power plug before
replacing blown fuse at the rear of unit.
Item no. 582013
Fuse 6,3 AM/250 V D 5 x 20
19