Wassermann Cemat-NT 4, User Manual

Page: 7 / 20

6.3 Installation
Open the box, remove the packing materials, and carefully lift out the device and
accessories. Check the included accessories.
The device has to stand horizontally on a steady and even surface.
Install the device in a place where it will not block the working area and the
functionality (take the dimensions into account).
Do not install the unit outdoors or in places without proper ventilation.
Before start-up, be sure the device reaches room temperature.
7 Installation/ Start-up
Before starting the unit, connect up the following:
•
Connect the unit to the compressed-air line.
•
The fine blasting unit has to be connected to an external suction unit. The nozzle is
at the lower rear.
•
Finally , insert the power plug into the socket, making sure that the mains and the
unit operate on the same voltage.
•
Fill the abrasive tanks.
•
Flip the (green) rocker switch.
•
The unit is ready for use as soon as it reaches operating pressure.
•
The abrasion process is blocked until the observation flap is closed.
7