Wasp Clay Kit, Getting Started, Page: 7 / 12

Getting Started
6
EXTRUDER CHANGE:
• Whith the printer OFF unplug the “A” connector (fig.1) of the
filament puller system, the rj45 “B” connector from the extruder
unit (fig.2) and unscrew the 2 screws “C” e “D” placed under the
extruder plate (fig.3).
• Remove the three rubber bends from the sliding parts (fig.4) and
remove the entire extruder block (fig.5), insert the LDM extruder on
the extruder plate and secure it with two screws placed under the
plate (fig.6). Plug now the “A” connector (fig.1) to the motor and turn
ON the printer.
• Insert the compressor hose into the “C” connector (fig.7) placed
before the pressure gauge and connect the “D” connector with the
“E” joint of the tank with the 4 mm hose (fig.8). Connect the 12mm
hose from the “F” joint of the tank to the “G” joint of the extruder
(fig.8).
A
D
E
B
C D
Fig.1
Fig.4
Fig.2
Fig.5
Fig.3
Fig.6
Fig.8 Fig.7
C
Fig.9
F
G