Output
3-14
DuraLine™ 2D Imagers
Scan
Centering On
, then scan one of the following bar codes to change
the top, bottom, left, or right of the centering window. Then scan the
percent you want to shift the centering window using digits on the
Save
.
Default Centering = 40% for
Top and Left, 60% for Bottom and Right.
Decode Search Mode
There are three selectable decode (scanning) modes:
Full Omnidirectional
- Searches for bar code features beginning at the
center of an image, and searches to the image’s limits. This mode reads
all symbologies (including OCR), in any orientation. The Full Omnidi-
rectional search is very thorough which may slow performance time.
NOTE
This search mode is the default setting.
Left of Centering Window
Top of Centering Window
Right of Centering Window
Bottom of Centering Window
*
Centering Off
Centering On
Full Omnidirectional
Summary of Contents for 2D
