Page 13
For technical questions, please call 1-888-866-5797.
Item 57342
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
Operating instructions
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO prEVEnt SEriOuS inJury:
Wear anSi-approved safety goggles and hearing protection during operation.
Wear heavy-duty work gloves when handling saw blades.
WarninG! tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
Make sure that the trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Blade changing
WarninG! tO prEVEnt SEriOuS inJury: Make sure that the saw blade is installed to rotate in the
proper direction. Do not use grinding wheels, wire brushes, or abrasive wheels on a table saw. improper
saw blade installation or use of accessories not recommended may cause serious injury.
Only use a 10″ saw blade with a 5/8″ diamond arbor, rated to at
least 4,250 rpM and intended for woodcutting.
note:
Saw Blade sold separately.
1. Turn Power Switch off and unplug
the tool from its power source.
2. Loosen Lock Knob, then move Blade Height
Handle to 0°. Tighten Lock Lever.
3. Turn Blade Height Handle to lower
the Blade completely.
Blade
Height
Handle
Lock
Knob
4. Raise Blade Guard Lock, then remove Blade Guard.
Blade
Guard
Lock
5. Remove Table Insert, pull up by using hole.
table
insert
6. Raise Blade completely, then move
Blade Height Handle to 15°.
7. Use two included wrenches, one to hold the
Inner Flange and the other to loosen the Blade Nut.
8. Remove Blade Nut, Outer Flange and Blade.
Blade
nut
Outer
Flange
inner
Flange
9. Install new Blade with teeth pointing forward.
Replace Outer Flange and Blade Nut, then,
tighten Blade Nut. DO NOT overtighten.
10. Move Blade Height Handle to 0°. Lower
Saw blade completely, then replace
Table Insert and Blade Guard.
