Page 10
For technical questions, please call 1-888-866-5797.
Item 57342
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
Saw Blade Selection
1. Any saw blade that will be used must be
marked as suitable for the material to be cut.
2. Match the saw blade diameter, kerf width
and body dimensions to the riving knife.
3. Use only saw blades that are marked with a speed
equal or higher than the speed marked on the tool.
Bevel angle Setting
1. Loosen Lock Knob, then move Blade Height
Handle until red indicator points to desired angle.
2. Tighten Lock Knob.
Blade Depth adjustment
note:
Blade depth should be set so that outer
points of blade are higher than workpiece
by approximately 1/8″ to 1/4″ and bottom of
gullets are below top surface of workpiece.
1. Loosen Lock Knob, then move Blade Height
Handle until red indicator points to 0°.
2. Tighten Lock Knob.
3. Turn Height Handle until desired depth is achieved.
riving Knife adjustment
note:
Riving Knife is permanently installed. It comes
in its lowest position for shipping. Reposition the
Riving Knife according to type of cut before use.
1. Remove Table Insert, pull up by using hole.
table
insert
2. Raise Riving Knife Lock.
riving
Knife Lock
3. Adjust Riving Knife to proper position for type of cut:
a. Through Cut
b. Non-Through Cut
4. Lower Riving Knife Lock and replace Table Insert.
