AIRCUT
-101
I
,161
IW
,200
IW Inverter Plasma Cutting Machine
WARPP ENGINEERS PVT LTD
3
health certification of consumptive materials, make sure they are innocuous.
4 Spatter
: Spatter can cause fire or explosion.
Remove fire hazards from the welding area. Remember that spatter from
welding can easily go through small cracks and touch fire hazards. Protect all kinds
of lines going though welding area, including hydraulic lines in the wild.
Where compressed gases are to be used in the field, special precautions should be used to
prevent explosion.
When welding stops, make certain that no live part is touching the work piece or the work
stage. Accidental contact can create a fire hazard.
Do not weld containers or lines, which are not proved to be innocuous.
It is very dangerous to heat, cut or weld tanks or containers at entry holes. Does not start
work until the proper steps have been taken to insure that there is no flammable or toxic gas.
Spatter might cause burn. Wear leather gloves, heavy shirt, cuffless trousers,high shoes and a
cap over your hair to prevent from burning by spatter. Wear the ear shield when performing
sideways or face up welding. Always wear safety glasses with side shields when being in a welding
area.
Thewelding cablesshould beasclosetothe weldingareaaspossible,andthe short,the
better. Avoid welding cables going through the building framework, lifting chains, AC or DC cables
of other welding machines and appliances. The welding current is strong enough to damage them
while having short circuit with them.
5 Cylinder
: Damage of it might cause explosion.
Make sure that the gas in the storage cylinder is qualified for welding, and the
decompression flow-meter, the adapter and the pipe are all in good condition.
Make sure that the installation of cylinder is by the wall and bundled tightly by a chain.
Be sure to put the cylinder in the working space with no crash or shake, and far from welding
area.
It is forbidden to touch cylinder with the welding clamp or the work cables.
Avoid facing the cylinder while installing the decompression flow-meter or the gasometer.
When not working, please tighten the valve.
6 Power
: (For electrically powered welding and cutting equipment) Turn off input power
before installation, maintenances and repair, so that avoid accident.
Warpp Engineers Pvt Ltd welding equipment is Ι class safeguard
equipment; please install the equipment in accordance with the manufacturer’s
recommendations by specific persons.
Ground the equipment perfectly in accordance with the manufacturer’s recommendations.
7 Power
:(For engine driven welding and cutting equipment)
Work in ventilated place or outdoors.
Do not add fuel near tofire or during enginestarting or welding. When not
working, add fuel after engine is cooling down; otherwise, the evaporation of hot fuel
would result in dangers. Do not splash fuel out of the fuel tank, and do not start the
engine until complete evaporation of the outside fuel.
