background image

Warner Shelter Systems Limited

PAGE 11

Care for your Vinyl Tops

Care for your vinyl tops as you would to any vinyl surface.

Use mild detergent industrial cleaner with no chlorox.

To clean, spread tent top on clean surface. Try laying fabric on astro turf to wash. Dirt and tiny sharp
particles tend to fall into the carpet pile, away from the fabric. Some renters set up the tents to wash
and dry.

Spray detergent solution onto fabric. Use more concentrated solution on soiled areas.

Rub, scrub or brush; elbow grease is an essential ingredient. Pressure washing may harm your tent
fabric and is not recommended. Rinse with clean water, hang cover and allow to dry thoroughly.

DO NOT 

put your tent away damp. Mold & mildew will grow and discolour the cover. Always dry the

tent. To speed things up, try fans or carpet air blowers and hanging the canopy.

Trees can be a problem with sap, pollen, etc. Flowers & leaves, sometimes contain powerful natural
organic chemicals capable of staining your beautiful tent. Beware of tents under trees!

- Always use a drop sheet during setup and take down.

- Have some cleaning equipment with you for on-site clean ups.

- Besides being a fire hazard, BBQ's add a lot of grease and grime to the underside of the tent and

are not recommended even with the walls off.

STORAGE

 - store vinyl canopies and other parts 

clean

 and 

dry

.

Maintaining Your Tent

Your 

WSSL Peak Marquee Tent

 will serve your needs now and for many years to come. Tighten the

top and walls to avoid wind flap and consequent wear on the fabric. Periodically the fabric should be
cleaned; in place or when dismantled. Using mild detergent, water and a deck mop, clean wipe the
fabric roof or walls. Let dry. Repair any damage to the fabric using a WSSL Fabric Repair Kit. Repair
or replace any possible damaged frame parts.

TENT FABRIC CHARACTERISTICS

MILDEW

 - If mildew is detected, remove it immediately. Regardless of treatment, there is no way to

absolutely stop fungus growth if it is prevalent in your area. No tent can be guaranteed not to mildew.
Vinyl fabrics may mildew in storage if not properly stored. BE SURE TENT IS CLEAN AND DRY
BEFORE STORING IN A COOL, DRY PLACE.

WATER RESISTANCE

 - WSSL tents are made of waterproof vinyl/polyester fabrics using waterproof

welded seams. Because these fabrics are impervious to moisture, condensation may occur with
some heaters and if the tent is poorly vented. Do not confuse water condensation with leakage
especially on vinyl tents.

FLAME RESISTANT

 - All WSSL tent tops and walls are fire retardant. All WSSL tent fabrics satisfy

ULC-S109, NFPA 701, and California fire marshal tests for fire resistance.

FADING-OPACITY

 - Variable sun conditions, exposures, types of materials and fabric finishes all

influence the weathering of fabrics. WSSL fabrics have been chosen for their colour and opacity
consistency and stability.

COLD CRACK

 - Chosen for their tolerance to cold cracking, our translucent fabrics remain flexible at

temperatures below  0°F. The opaque fabrics are laminated and therefore become stiffer as the
temperature drops. When the temperature is near 32°F, care should be taken in folding and moving the
fabric to prevent cracking of the vinyl, especially the walls with windows.

..\graphicshome\marquee\manuals\MQ 20\MQ20H Manual 2009.pdf

Summary of Contents for MQ20H













Reviews: