![background image](http://html1.mh-extra.com/html/warner-electric/mcs2000-psdrv2/mcs2000-psdrv2_installation-and-operating-instructions-manual_873113005.webp)
5
Warner Electric • 800-825-9050
P-2010-7 • 819-0525
System Wiring
Controllers
The MCS2000-PSDRV2 will operate with any of
the MCS2000 series Controllers. It will provide
interface between the brakes and the MCS2000-
ECA, MCS2000-CTDA or MCS2000-CTLC
Tension Controls. Additionally when the
MCS2000-ECA is used, the MCS2000-PSDRV2
can supply the 24 VDC power for operating the
controller as well.
Wiring between the various controls will vary
somewhat, but for all practical purposes are pretty
similar.
The MCS2000-PSDRV2 will operate with any of
the 24 volt Warner Electric Tension Brakes or
Clutches as long as the maximum current rating
per channel is not exceeded.
Wiring to the MCS2000-ECA Control
Refer to Figure 2 for wiring hook-ups.
CAUTION:
It is recommended that shielded cable
or twisted wire pairs be used to minimize the
possibly of noise affecting either the controller or
driver circuitry. Additionally, lead lengths should
be kept as short as possible.
Note:
Also refer to MCS2000-ECA Manual for
exact terminal strip locations and
designations.
o
1.
Connect a wire from terminal Out 1 (V) on
the MCS2000-ECA to terminal number 1
InA 0-10 V on the MCS2000-PSDRV2.
Insure that both terminals are tightened
securely.
o
2.
Connect a wire from terminal Out 1 (0V) on
the MCS2000-ECA to terminal number 2
0V on the MCS2000-PSDRV2. Insure that
both terminals are tightened securely.
If a dual brake system is to be used, then proceed
to step 3.
If only a single brake is to be used on the
MCS2000-PSDRV2, then skip to either the 24 volt
brake wiring section, page 8 or the 48 Volt brake
wiring section, page 10.
o
3. Connect a wire from terminal Out 2 (V) on
the MCS2000-ECA to terminal number 3
InB 0-10 V on the MCS2000-PSDRV2.
Insure that both terminals are tightened
securely.
o
4.
Connect a wire from terminal Out 1 (0V) on
the MCS2000-ECA to terminal number 4
0V on the MCS2000-PSDRV2. Insure that
both terminals are tightened securely.
o
5.
This completes the wiring between the
MCS2000-ECA and the MCS2000-
PSDRV2. Double check all wiring before
proceeding to the next section.
o
6.
Proceed to either the 24 volt brake wiring
section, page 8 or the 48 volt brake wiring
section, page 10 of the manual.