Warn Industries
PAGE 2
89786 Rev. A0
NOTE
: This unit is to be used only on vehicles equipped with a Warn Front Receiver or a class
3 receiver trailer hitch.
1. First, remove the cover as shown in
Figure 1
below.
FIGURE 1
Set the cover aside and remove the three (3) nuts connecting the BUS Bars to the electric
motor as seen in
Figure 2
below.
FIGURE 2
2. Remove the four (4) screws holding the control pack to the winch. This is done by first
setting the winch on its back to remove the front two (2) screws (shown in
Figure 3
) and
then on its front to remove the two (2) screws in back.
REMOVE BOLT
AND COVER
REMOVE NUTS
AND SET
