USING THE MOUNTING
BRACKET AS A GUIDE, MARK
THE BODY SILL THROUGH
THE 5/16” HOLES.
Figure 4: Place rock slider on sill and mark the two 5/16” rear holes on each side of vehicle
Once the 5/16” holes are drilled, proceed to the next section for installation.
3. Install the rock sliders
Place the appropriate rock slider on the side of the vehicle. Install a 3/8” x 1-1/4” long bolt with flat washer
through each of the four 3/8” hole locations. Install a 5/16” x 1-1/4” long bolt and flat washer through each
of the two 5/16” rear hole locations. Install a 3/8” flat washer, 3/8” lock washer and 3/8” nut onto each of
the four 3/8” bolts. Install a 5/16” flat washer, 5/16” lock washer and 5/16” nut onto each of the two 5/16”
bolts. Do not tighten the bolts at this time.
See Figure 4.
WARN INDUSTRIES
PAGE 5
75732 A0
