Figure 4: Install four 3/8” bolts and washers through the mounting bracket and then the body sill.
Install two 5/16” bolts and washers through the mounting bracket and the two previously drilled
holes in rear mounting bracket.
Using
Figure 5 and 6
as a guide, install the nut and rod assembly through the access cutouts and hold the
nut over the slotted holes in the floor mounting locations. Install a 7/16” x 1-1/4” long bolt with a 7/16” lock
washer and 7/16” flat washer through the mounting bracket, underside of body and into the nut assembly.
Repeat this for the front and middle mounting bracket locations.
WARN INDUSTRIES
PAGE 6
75732 A0
