©2019 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
5
106693A0
I N S T A L L A T I O N I N S T R U C T I O N S
5. Carefully remove bumper and set on a clean and stable
surface.
6. If your bumper is equipped with sensors, carefully
remove from the carriages.
NOTICE
Be sure to mark
the location and orientation of each sensor plug.
TIP: Numbering each sensor with tape and marking the top
with a paint pen works well.
7. Release the plastic clips holding the wire harness in place
and remove harness from bumper completely.
8. Unsnap trailer plug from stock bumper.
9. Remove license plate lights from stock bumper by
removing the bolt on the rear of each housing with a
10mm wrench.
10. Reinstall trailer plug and license plate lights into new
bumper.
11. Install the sensor carriages into the new bumper by
either of the two methods below:
a. Using a razor blade, cut the sensor carriages out of
the stock bumper and carefully glue into the new
bumper with a waterproof adhesive or epoxy.
b. Order new carriages for the
FRONT
bumper of your
specific year and model from a Dodge dealer and
press them into the holes on the new bumper.
12. Install sensors into carriages.
NOTE: Be sure sensors
match the same orientation of the stock bumper.
13. If installing lights, install now. If not, install light plate
(A3) using two M6 screws (B3) (each side). Refer to
exploded view on page 3.
14. Install frame brackets (A2) to bumper using four M10
bolts (B5) and nuts (B4).
Do not fully tighten to allow for
adjustment.
Refer to exploded view on page 3.
Figure 4
Figure 5
Sensors
Trailer Plug
License Plate Lights
Sensors
Trailer Plug
License Plate Lights
A3 and B3
Figure 6
Figure 7
A2
A2
B5
&
B4
B5
&
B4
B5
&
B4
B5
&
B4
