Warmup 4iE WiFi, Installation Manual

Page: 4 / 24

Mounting/Positioning
4
Loosen both screws at
the bottom of the 4iE
and remove the Back
Plate
Install a 35mm deep
electrical back box
in your preferred
thermostat location
4iE
Step 1 - Install Back Plate
1 2
Before making any permanent fixtures Warmup recommends
identifying your preferred location for the 4iE . It should be
located in an area with good ventilation. It should not be beside a
window/door, in direct sunlight or above another heat generating
device (e.g. radiator or TV).
Ensure the distance from your router to the 4iE is not too great.
This will ensure the wireless connection is not subject to range or
interference issues once installed.
BATHROOM INSTALLATIONS:
When installing a 4iE within a
bathroom it MUST be mounted outside of Zone 2 in accordance
with the Wiring Regulations. If it is not possible to identify a
suitable location outside of Zone 2 within the bathroom, then it
is recommended that the 4iE is installed in the adjacent room
and set to control the heating by floor temperature only. When
installed in this way, it is not possible to directly control the
heating based on the room air temperature, only the floor surface
temperature.