INSTALLATION OF THE DEVICE
Instructions for mounting the heater on feet
Instructions for wall mounting
1. Fasten the 2 brackets to the wall according to the hole spacing shown in in the drawings
below, taking into account your heater model.
24
190 mm
16 mm
8 mm
50 mm
Mounting Hole Distances for Wall Brackets
(EGW-1000)
16 mm
8 mm
50 mm
Mounting Hole Distances for Wall Brackets
(EGW-1500)
320 mm
16 mm
8 mm
50 mm
Mounting Hole Distances for Wall Brackets
(EGW-2000)
450 mm
1. Place the heater upside down on a soft cotton cloth or a
carpet. Alternatively, place the device glass front up, on a
flat surface that will not hinder the installation of the feet.
2. Install the feet in the appropriate place of the lower part
of the product, and then fasten with screws with the help of
screwdriver and tighten. (Fig.1)
ATTENTION!
Do not operate the heater if the feet are not attached or if the device is not
properly attached to the wall.
To eliminate the risks associated with the possible overturning of the heater, it has been
equipped with a tilt sensor. Thanks to this, in case of loss a balance or fall of the device, the
sensor turns off the power supply.
(Fig.1)
Summary of Contents for EGW-1000
