25
Push Button Ignition Installation
Plate
CROSSFIRE
Brass Burner
Straight
Jet
Drill Here
.125"
CROSSFIRE
Brass Burner
Tilted Jet
Drill Here
.125"
Plate
STEP 2:
Place
wires through drilled
hole and pull through
until Spark Igniter
bracket is in place on
plate.
STEP 2 - SIDE VIEW, tilted jet
Spark
Igniter
Spark
Igniter
Plate
Plate
STEP 3:
Screw
Spark Igniter to
plate. Make sure tip
of Spark Igniter sits
no further than .125"
away from the inside
edge of the jet.
NOTE: If Spark Igniter
is too high when
flush with plate,
run mechanism up
through bottom of
plate.
.125"
.125"
STEP 1:
To place
Spark Igniter in
proper position, the
installer will need
to drill a hole in the
plate.
Measure where to
drill holes by holding
tip of Spark Igniter
no further than .125"
away from inside
edge of jet. Drill hole
where base of Spark
Igniter sits.
NOTE
: If the burner being installed uses a titled jet, use the 3.0" Spark Igniter. If the burner uses a straight jet, use the
3.25" Spark Igniter.
Use the 3.0" Spark Igniter
Use the 3.25" Spark Igniter
Push Button Ignition
