Warmhaus LAWA, Installation & User Manual

Page: 18 / 28

18
3.2.6. Selection of On/Off/Standby and Summer/Winter Modes
ON/OFF button is not available on the combi panel. Switching on/off
should be performed on the V automat switch connected to the combi
line.
3.2.7. On/Off/Standby Positions
ON/OFF button is not available on the combi panel. Switching on/off
should be performed on the V automat switch to be connected to the
combi line.
3.2.8. Operation at Winter Position
At that position, combi operates both for heating the environment
and providing hot tap water. Radiator temperature adjustment is made
with (3) and (4) numbered buttons in Figure 28, Domestic Hot Water
temperature adjustment is made with (7) and (8) numbered buttons and
this temperature is indicated with (10) numbered indicator for Radiator
and with (12) numbered indicator for Domestic Hot water.
Analogue manometer is located near to right-bottom side
of the combi. Installation pressure should be seen in this
manometer even in the absence of electricity.
When combi is started, flame modulation symbol is seen at the middle
section of the screen. At that position, you can increase and decrease
the temperature with radiator temperature adjustment buttons (see.
Figure 28) (3) between 35 – 80 °C, screen lights when buttons are
pressed and °C symbol flashes besides the radiator temperature value.
3.2.9. Operation at Summer Position
Combi only operates for heating the domestic hot water at that
position. In order to switch to domestic hot water position;
3.2.10. Shutting Off the Combi
To bring the combi to OFF position while it is in SUMMER position;
When the combi is started for the first
time, screen displays nG letter and then
a number (for instance 24) indicating kW
power of the device.
Then, OFF letter is displayed,
and screenlight is closed. Now, combi is
at STANDBY position. The temperature
value when electricity is supplied to the
device is the temperature value of water
in the installation.
Hold the MODE button for switching on
the combi when letter is available on the
screen.
A cycle starts on the screen.
release the button when cycle is
completed.
In some cases, combi initially gets into
Radiator position, its symbol flashes on
the left bottom corner of screen and
tap symbol is seen at right bottom
corner. A digital manometer indicating
the installation pressure is located on
the lower middle section of the screen
and also existing radiator installation
temperature is seen on the screen at the
same time and screen light is turned off.
{If you have a ground heating system, as our Authorized
Service adjust your combi for “Low Temperature
Operation”, maximum temperature shall be limited with the
Radiator temperature adjustment button (3) (e.g. maximum
50 °C)}.
Domestic Hot Water Adjustment at Winter
Position; You can adjust the hot tap water
temperature value between 35 – 60 °C
with (7) and (8) numbered buttons under
the RESET button. Screen lights during
temperature change, DHW symbol flashes
besides the DHW temperature value. Screen
light turns off after adjustment.
If you are starting the combi for the first
time hold MODE button, and release
the button after the cycle is completed
on the screen, initially combi switches
to radiator position, its symbol will flash
on left top corner of the screen existing
radiator installation temperature and
screen light will turn off.
In order to switch to tap water position,
hold MODE button and release the
button after completion of cycle on the
screen. At that position, symbol flashes
at right bottom corner of the screen and
existing domestic hot water temperature
will be seen on the screen and screen
light will turn off.
At that position, you can adjust the hot
tap water temperature between 35 –60
°C with (7) and (8) numbered buttons
below the RESET button.
Screen lights during temperature change,
DHW symbol flashes besides the DHW
temperature value. Adjustment value is
confirmed after screen light turned off
following the adjustment.