Instructions for Use
The fireplace can be operated either by the switches (located on the top right hand
side of the fireplace) or by the supplied remote control.
Manual Operation
The switches are located at the top right hand side of the fireplace. The standby
switch must be switched on first.
Press the button once to turn on the appliance and fire effect. A red indicator light
will appear to indicate that the function is on.
Press the 750W button once for the low heat setting; press again to switch it off.
Press the 1500W button once for the high heat setting; press again to switch it off.
Remote Operation
The standby switch located at the top right hand side of the fireplace must be
switched on first.
It takes some time for the receiver to respond to the transmitter. Do not press the
buttons more than once within two seconds for correct operation.
Press the button once on the remote control. This turns on the appliance and
fire effect.
Press the 750W button once for the low heat setting; press again to switch it off.
Press the 1500W button once for the high heat setting; press again to switch it off.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fireplace overheats (e.g.
due to blocked air vents). For safety reasons, the fireplace will NOT automatically reset.
To reset the appliance, disconnect it from the main power supply for at least
15 minutes.
Reconnect the supply to the main power supply and switch on the appliance.
Battery Safety
Do not mix alkaline, standard (carbon zinc) and rechargeable batteries (nickel
hydride).
Do not mix old and new batteries.
Non-rechargeable batteries should not be recharged.
Rechargeable batteries should be removed from the fireplace before being charged
(if removable).
Rechargeable batteries should only be charged under adult supervision (if
removable).
Exhausted batteries should be removed.
Only batteries of the same or equivalent type as recommended are to be used.
The supply terminals should not be short circuited.
Batteries are to be inserted according to the correct polarity.
Do not dispose of batteries in a fire.
