This appliance is designed to be permanently fixed to a wall at a minimum height
of 600mm. The wall bracket must be fitted horizontally and the cable routed to the
bottom right of the heater.
A height of 600mm from bottom of heater to floor is recommended for optimum
viewing of fuel bed see fig.1 for recommend fixing dimensions.
Use the bracket as template and mark five drill positions on the wall.
Make sure that these holes are level. Observe the recommended fixing dimensions
(Fig. 2).
Put the bracket aside and drill holes with a depth of 35 mm using an 8 mm drill bit.
Clean the holes of dust and insert one plug in each hole. Make sure the edge is flush
with the surface.
Hold the bracket in position and fix it with screws.
Attach the fixing angle to the bottom of the appliance using the short screws.
Carefully lift the appliance and hook it to the wall bracket (Fig. 2, circle). Do not let the
appliance go until you are sure it is safely engaged to the bracket.
Now mark the hole position for fixing the angle (Fig. 3). Carefully remove the appliance
from the bracket and drill holes with a depth of 35 mm using an 8 mm drill bit.
Clean the holes of dust and insert one wall plug in each hole. Make sure the edge is
flush with the surface.
Then lift up the appliance again, engage it to the bracket and finally fix the angle
with screws.
Fig 1
600
