Operation
This piece of equipment is designed for the high speed blending,
pulping, mixing or reducing of animal tissue, vegetables, foodstuffs,
plant materials and other substances. A typical operating sequence is
as follows:
1. Add materials to be processed to container.
2. Place cover on container.
3. With the power switch on OFF position, place container on
blender. Be sure container is fully seated and the drive coupling
is properly engaged.
4. Set power switch to ON, Low or High position.
5. When finished processing, set power switch to OFF position.
6. Allow motor to come to a complete stop before removing
container from blender.
Note:
Containers with removable bottoms have left-handed threads.
To tighten, turn in direction of molded arrow on underside of removable
bottom. When reassembling, be sure rubber gasket is positioned
between the container and the flange on the blade assembly.
Important
HOT BLENDING INSTRUCTIONS
To minimize possibility of scalding when blending hot materials, the
following precautions and procedures must be observed.
1. Limit amount of material processed to 1/2 pint.
2. Completely remove the center portion of the two-piece container
lid before starting motor. (This will allow venting of the rapidly
heated and expanding air present inside container when blender
is running.)
3. Always start blending lowest speed setting, then progress to
desired speed.
4. Never stand directly over blender when it is being started or while
it is running.
To Operate Timer Model Only
Blender
One Quart Capacity Specifications
• Ratings
120 VAC – 50/60Hz – Single Phase
230 VAC – 50Hz – Single Phase
• Motors
Permanently lubricated series-wound universal type
• Timer
Selective timer cycle from 1 to 180 seconds for
automatic continuous running
• Bases
Zinc die casting with epoxy enamel finish or polished
stainless steel
• Containers Stainless steel, borosilicate glass, polycarbonate or
san plastic
• Cord
6 foot – 18 gauge – three conductor grounded cord with
strain relief
• UL Listed
120 models only
Grounding Instructions
• For your protection, Waring Commercial Blenders are equipped with a
3-conductor cordset.
• 120 Volt units are supplied with a molded 3-prong grounding-type plug and
should be used in combination with a properly connected grounding-type
outlet
If a grounding-type outlet is not available, an adapter, shown in Figure 2, may
be obtained to enable a 2-slot wall outlet to be used with a 3-prong plug.
Referring to Figure 3, the adapter must be grounded by attaching its
grounding lug under the screw of the outlet cover plate.
Caution:
Before using an adapter, it must be determined that the outlet cover
plate screw is properly grounded. If in doubt, consult a licensed electrician.
Never use an adapter unless you are sure it is properly grounded.
Note:
Use of an adapter is not permitted in Canada.
Green/Yellow: Earth Ground
Blue: Neutral
Brown: Live
