3
890667_c•en•01.09.2014
We reserve the right to carry out improvements
Button/
display
Cction/result
Uo learn in the comfort position:
The transmission LED
indicates that
transmission is occurring:
2s GREEN: The comfort position is
stored
2s RED:
The command was not
confirmed (e.g. receiver
outside of transmission
range); repeat the procedure
Uo recall a comfort position:
Briefly press the comfort button
.
The transmission LED
flashes green.
The comfort position for the selected
product is restored automatically.
IUE
O
If a product is already in the comfort position or
if a comfort position has not been stored, the
selected product does not respond to pressing
of the comfort button
:
IUE
O
When the comfort position is not moved to
correctly, the run time in the receiver must be
adjusted with a WMS Central transmitter or a
WMS Hand-held transmitter (please see the
operating instructions of the respective receiver).
Switching on/off the comfort control functions
Button/
display
Cction/result
Press the control button
.
The transmission LED
flashes green.
The transmission LED
lights up:
GREEN:
The control
functions are
switched on in all
receivers
RED:
Not all receivers could be
reached; switch the control
functions OFF and ON again
(or ON and OFF).
The A LED lights up:
GREEN:
Switch on the control
functions
RED:
Switch off the control functions
The hand-held transmitter basic always remembers the
command last sent. When the control button
is pressed
again, the hand-held transmitter basic sends the opposite
command (ON - OFF - ON -...).
Commissioning
Films on commissioning can be found at:
http://www.warema.de/inbetriebnahme-
funksysteme
We recommend commissioning using the
WMS studio PC software.
Insert the supplied batteries into the battery
compartment as described in the "Maintenance and
cleaning" section. The device is ready to operate.
IUE
O
Before WMS receivers can be operated via a
hand-held transmitter, the hand-held transmitter
or the receiver must be included as a device in
a radio network.
The application examples below are intended to make it
easier for you to perform the procedures you require.
Example 1:
Uhe existing system with a WMS Hand-held
transmitter is expanded to include a WMS Hand-
held transmitter basic
Step 1
Cdd the WMS Hand-held transmitter basic to the existing
network
Button/
display
Cction/result
Wake up the WMS Hand-held transmitter
basic with the STOP button
Wake up the (large) WMS Hand-held
transmitter with any product button
Press the learn button on the large WMS
Hand-held transmitter for approx. 5 s
+
lights up green; the transmission LED
flashes. For several seconds, the
hand-held transmitter scans the range for
devices.
E.g.
When the scanning procedure is
completed, the located devices are
displayed in the upper row of LEDs (here,
for example, 2 receivers).
RED:
New
device
GREEN: The device already belongs to
the network
Devices that already belong to a different
network are not located during scanning.
Select the desired device using the arrow
buttons.
(Briefly press
to check which device is
currently selected. The product waves.)
E.g.
The LED of the selected device flashes on
the large WMS Hand-held transmitter.
Press the STOP button
on the large
WMS Hand-held transmitter to add the
WMS Hand-held transmitter basic to the
network.
E.g.
The LED of the selected device flashes
green. The WMS Hand-held transmitter
basic has been successfully learned into
the network.
You can now add additional scanned products in the
same manner.
Briefly press the learn button to leave the
learn mode.
