890667_c•en•01.09.2014
We reserve the right to carry out improvements
2
Pos. Fig. Function
A
Control on/off button
Switch on and off the control functions of the
receivers that were learned in.
Control function LED with two functions
When you press the control button
, the
LED indicates whether the comfort control
functions are active or inactive.
If operation is blocked on your hand-held
transmitter, for example due to a wind alarm,
this LED flashes red. (The wind alarm keeps
your sun shading systems safe. When the set
wind speed limit is exceeded, the blinds are
retracted and manual operation is blocked
during this time.)
+
Uhe control function LED
a
nd transmission
LED
flash
ORANGE: Hand-held transmitter basic is in its
factory state (does not belong to a network, still
needs to be learned in).
IUE
O
If the two buttons flash red, you
pressed the button for too long
and you are now in the factory
mode. To leave this mode, press
the learn button briefly
.
4
Uransmission LED
flashes
GREEN:
The hand-held transmitter basic is
transmitting.
RED: The hand-held transmitter basic did not
receive a response from the receiver
ORANGE: Change the batteries
5
AP/SUIP/DIWO buttons
Send move or switch commands to the selected
receiver. If the hand-held transmitter basic is in the
info or learn mode, the buttons can be used to
change or store settings.
6
Comfort button
This button can be used to store and call up
comfort positions.
Iperating elements on the back
Fig. 3 Back of the WMS hand-held transmitter basic
Pos. Fig. Function
7
Batteries
The hand-held transmitter basic requires two
batteries of type AAA (IEC LR03, "Micro")
8
Learn button
Activates or closes the learn mode of the hand-
held transmitter basic
9
L LED
Indicates that the hand-held transmitter is in learn
mode (lights up green)
Iperation
Iperating the products
Button/
display
Cction/result
Operate the selected product using the
UP/STOP/DOWN buttons.
The operating instructions of the respective
receiver describe which operating options are
available to you (e.g. UP=ON, DOWN=OFF,
STOP=switch).
The transmission LED
indicates that
transmission is occurring:
Flashes GREEN:
The hand-held
transmitter is transmitting, then:
Lights up GREEN
for 2s:
The receiver has
confirmed the command
Lights up RED
for 2s:
The command has not been
confirmed (e.g. receiver is
outside of the transmission
range),
or
the hand-held transmitter
was added to the network
but a channel has not yet
been copied onto the hand-
held transmitter.
Lights up GREEN
for 2s + control symbol is red:
The receiver confirms the
command, but does not
execute it because of the
displayed control function
(e.g. the awning is not
extended because the wind
alarm is active).
The transmission LED
indicates that
transmission is occurring:
Lights up RED
for 2s:
The hand-held transmitter
was added to the network
but a receiver has not yet
been assigned.
Learning/recalling the comfort positions
A comfort position can be stored for the receivers in the
network (e.g. awning half extended). The awning can be
automatically moved to this comfort position at the press
of a button.
Button/
display
Cction/result
Uo learn in the comfort position:
"Move your product to the position that is
to be stored as the comfort position (see
"Operating the products").
Hold down the comfort button
for 5
seconds until the transmission LED
lights up.
