890362_b•en•21.03.2011
We reserve the right to carry out improvements
10
WAREMA Quatronic dialog
®
Operating instructions
3 ommissioning
Commissioning of the Quatronic dialog is described in detail in the
Instal-
lation Instructions
. The device will only function correctly if the settings are
adjusted during commissioning to the products being controlled.
NOTE
If your specialist for sun shading products had the Quatronic dialog installed
by a certified electrician, all device parameters have been set.
The comfort functions are adjusted to your requirements during commission-
ing.
AATIOA
Do not make changes to the safety settings that may result in damage to
your sun shading products.
The safety functions of the Quatronic dialog protect the controlled sun shad-
ing products against damage due to the weather conditions. All parameters
were set correctly during commissioning.
3.1 Operational readiness
Approx. 5 minutes after the supply voltage is switched on, the current time,
day of the week and date are automatically read in via the radio clock aerial
connected to the wind/photo/radio clock sensor. (The question mark behind
the time disappears. If reception is disturbed, the question mark behind the
time does not disappear. See
Chapter 8.3 on page 62
).
When the time on the Quatronic dialog is set correctly, the device is ready for
operation.
3.2 Languages
The Quatronic dialog supports multiple languages. The display language can
only be selected with the supply voltage switched off. This procedure is de-
scribed in the installation instructions and should be carried out by an expert
during commissioning.
3.3 Reference
All factory settings are listed in
Chapter 16 on page 70
. A table for entering the
individual settings can be found in
Chapter 17 on page 71
.
ommissioning
