WANHAO Duplicator 4, User Manual

Page: 15 / 48

---------------------------------------------------------------------------------------------------------------------------------------------
INSTALLING FILAMENT GUIDE TUBE AND SPOOL HOLDER
6. Installing the Filament Guide Tube
A.
Locate the filament guide tube.
Insert one end into the hole at
the top of the extruder and push
the tube in as far as it will go.
B.
Insert the other end of the
filament guide tube into the left
guide tube holder (when viewed
from the back) on the back of the
WANHAO Duplicator 4/4x. Make sure
that the end of the filament guide
tube is flush with the bottom of
the guide tube holder. The filament
guide tube should not hang down
past the bottom of the guide tube
holder.
7. Installing the Spool Holder
A. Locate the spool holder. Tilt the spool
holder and insert the round end
into the left side opening on the back
of the WANHAO Duplicator 4/4x (when
viewed from the back).
-----------------------------------------------------------------------------------------------------------------------------------------
--------
14
SETTING UP YOUR WANHAO DUPLICATOR 4/4x DESKTOP 3D PRINTER