W&T 58620, Manual

Page: 71 / 89

71
W&T
Appendix
Subject to error and alteration
After successful opening of a connection and entering the
system password (if configured) you are taken to the main
menu of the LAN-Modem network stack.
To navigate enter the number of the desired submenu followed
by <
Enter >. Entering < Enter > without preceding it by an
identifier returns you to the previous menu level.
All settings are first stored only temporarily. To save all settings
in non-volatile memory run
4. Save Setup in the main menu.
A1.2 Configuration of the TCP server port (Local Port)
Menu:
3. SETUP Port 0 -> 3. TCP/IP Mode -> Local Port
Default: 8000
This setting specifies under which TCP port number the LAN-
Modem can receive calls from a different LAN-Modem or virtual
modem port. If the value set here is other than 8000, the
corresponding target port number must be specified explicitly
a l o n g w i t h t h e d i a l - u p c o m m a n d ( e . g .
ATD192.168.0.10,44555). For additional information about
specifying the port number in the AT dial-up command see the
section
All AT Commands -> D(ATD) .