WamBlee W440, Instruction Manual

Page: 13 / 16

Signalling following TEST MOB message
If you receive a message such as 'SART TEST' or 'MOB TEST' (test
message), the relay contact will not change.
Based on firmware version (see yellow label on external case):
< 1.3
Firmware
You can ear only a 2 seconds beep, which indicates
the receipt of the message.
≥ 1.4
Firmware
You can ear a continuos 1 seconds beep with a 0.5
second pause. To stop this alarm, please switch off
the W440 unit.
Turning off the alarm and reset
To turn off your device W440 or reset an alarm received, simply move the
switch in position A.
Please note that The programmable ID codes stored in the table remain in
memory even turning off the device.
NMEA proprietary sentence output
The W440 is able to generate a NMEA 0183 sentence (4800 baud)
repeated every two seconds. This ruling is as follows:
$PWBEE,MOB_SWITCH,ON*<crc>
where:
ON = as close contact
Further clarification on the use of this NMEA sentence can be requested
directly to our technical department.
13
EN