WamBlee W440, Instruction Manual

Page: 14 / 16

Periodic checks
It is advisable to check with a certain periodicity (at least once a month)
your W440 system, the control can be done using the devices on board AIS
MOB TEST mode and check their recognition as described in paragraph "a
result of activation MOB alarm message. "
Programming by the Personal Computer
Starting from firmware version 1.3 it is possible to program the ID AIS
codes also through the use of a personal computer suitably connected to
the NMEA input port (pin 6 & 7 of the lower connector, see figure point 4).
The software is free and it can be downloaded from the company website
www.wamblee.it under the heading “W440”.
It allows you to set any ID AIS code without having to use the procedure
described on page 11.
The information on how to use and connect the software can be found
through the selection of the item 'Help' on the main menu of the same
software.
Troubleshooting
Should the device fail to pass the periodic check it will be necessary to
send your W440 to our after-sales service, which will restore proper
performance.
A list of after-sales authorized dealer to carry out maintenance on your
device can be consulted on our website:
www.wamblee.it
14
EN