Rev. 1.2
Assembly Instructions
– Dosing Pen VMS-13-EH
Page 7 of 20
Walther Systemtechnik GmbH
– D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de
3 Transport
3.1 Packaging
The type of packaging depends on the individual mode of shipping. If not separately contracted, the
packaging is in accordance with the rules and regulations of Walther Systemtechnik GmbH. This rule is in
accordance with the Federal Association for Packaging HPE.
3.2 Tasks before Transport
The following has to be done before transport:
Disconnect all power lines.
The actual transport of the incomplete device and its individual parts requires special care in order to prevent
damages from external forceful impact or careless on- and off-loading. Depending on the mode of
transportation, suitable transport and load securing has to be selected. The incomplete device will be aligned
and leveled by appropriate fastening elements
.
4 Description of Function
The dosing pen
VMS-13-EH
is operated by a manual trigger/actuation. The spraying material will be supplied
from a pressure container or via a pump to the valve. The needle will be pulled back and releases the
material which is then discharged from the nozzle. The actual application image can be adjusted via the
nozzle or the nozzle extension, as well as the material pressure and the needle stroke settings.
4.1 Designated Purpose
CAUTION
The use of other media can cause functional failures, damages or even the destruction
of the device.
The
VMS-13-EH
dosing pen is a high-precision device which will be a long-term reliable tool if the following
notes are observed
The function of the needle is as follows:
Open by using the external controls and close after turn-off of external controls through the spring pressure.
