Walther Systemtechnik S11 series, Assembly Instructions Manual

Page: 15 / 28

Rev. 1.4
Assembly Instructions
– Spray Valve SMS-11
Page 15 o f 28
Walther Systemtechnik GmbH
– D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de
– info@walther-2000.de
7.6 Troubleshooting
7.7 General Information
IMPORTANT
First check all supply lines for connection and serviceability.
In case of serious problems that cannot be resolved, please contact the Walther Systemtechnik GmbH
customer service.
7.8 Customer Service / Support
Walther Systemtechnik GmbH
Hockenheimer Straße 3
D-76726 Germersheim
Germany
Phone ++49(0)7274-7022-0
Fax ++49(0)7274-7022-91
Email info@walther-2000.de
Internet www.walther-2000.de
7.9 Malfunctions
Error Possible Cause Action
Nozzle needle does
not open Not enough control air supplied
Check if enough control air available (3 -
6 bar).
Leakages Check if O-Ring (7.5) is defective.
Needle is sticky within the needle sealing Disassemble and clean.
Needle stroke is set too low. Check if needle stroke is correctly set.
No atomizer air Atomizer air pressure set too low Check if sufficient atomizer air (see also
Technical Data 4.2) is applied to the
spray valve
No material
discharged Nozzle is clogged by material Clean nozzle and needle (see also 7.4 ).
Material pressure is set too low Check if sufficient material pressure
(see also
4.2 Technical Data) is applied
to the spray valve
Spray image not
correct Air cap is dirty Clean air cap
Wrong air ratio See chapter 7.10