3
2.2 Preparing for installation
The correct position of the tool parking station must be established before the tool parking station is
removed from the packaging. The following information is therefore included on the packaging produced by
WALTHER-PRÄZISION:
-
Drawing number
-
Ident number
The following points should be observed:
-
The tool parking stations must not be parked without being secured against tipping over. Due to its great height,
it may tip over under even the slightest collision.
-
No tool sides should be stored in a tool parking station that is not properly affixed to its location.
-
No tool sides must be stored in the tool parking station if no torque support is available.
If this is not observed, serious consequential damages may be the result.
WALTHER-PRÄZISION assumes no guarantee and accepts no liability in
these cases and all other cases of negligent acts resulting in damage or
injury.
3 Parking types and the associated parking arms
3.1 Horizontal parking 95816 (bolt-bush)
Parking arms:
Bearing for MM1 (right)
1-91489-B-00004-36-Z02
ident no 67972
Bearing for MM1 (left)
1-91489-B-00005-36-Z02
ident no 67973
3.2 Horizontal parking 95813 / 95817 (bar guide, bearing bolts)
-
Parking arms:
Bearing right (WS)
1-91489-B-00009-36-Y10
ident no 75132
Bearing left (WS)
1-91489-B-00010-36-Y10
ident no 75133
