WALMEC Asturomec 6010 sp HVLP, Instructions Manual

Page: 18 / 68

18
Ø
Feed **Product load Air consumption Fan dimensions
at 20 cm (7.9”)
Delivery
pressure
2.2
2.5
3.0
200-240 Lt./min (7 - 8.5 CFM)
200-240 Lt./min (7 - 8.5 CFM)
200-240 Lt./min (7 - 8.5 CFM)
200-240 Lt./min (7 - 8.5 CFM)
200-240 Lt./min (7 - 8.5 CFM)
200-240 Lt./min (7 - 8.5 CFM)
20 cm (7.9”)
22 cm (8.7”)
25 cm (9.8”)
1780 Gr/min.(63 oz/min.)
1960 Gr/min.(69 oz/min.)
2750 Gr/min.(97 oz/min.)
Suction
Suction
Suction
SP version
SP version
SP version
2.5-3.0 bar
(36-43 psi)
MOD.
..............................................................................
9010 ECOMIX - 9010 sp ECOMIX
...
TECHNICAL SPECIFICATIONS
...
USE
...
ADVICE FOR CORRECT USE
...
ADJUSTMENTS
- Air fitting: G 1/4” M
- Product delivery fitting (version SP): G 1/4” M
- Maximum air pressure: 5 bar (73 psi)
- Maximum product pressure (SP version): 5 bar (73 psi)
- Working pressure: 2.5-3.0- bar (36-43 psi)
- Fan: Fully open
- Air: Fully open
- Product: 2.5 turns
** Product flow was calculated with water, setting the recommended regulations.
The 9010 ECOMIX spray gun has been designed for special applications, especially in the building sector.
Specially indicated for applying Alfatone and wall paints. The instrument is not suitable for the application of products contai -
ning acids or any type of petrol.
To obtain the best results, the following instructions must be followed carefully:
1.
When possible, use an air pipe with a minimum internal section of ø 8 mm (0.3”).
2.
Make sure the compressed air used is perfectly filtered removing all water, oil or other impurities (for example, by installing
an Asturomec filter regulator ref. 61131 and Asturomec coalescent microfilter ref. 61201, or by the more complete and efficient
WALCOM TD
3
PRO multifunctional filter and heating unit).
1. The distance between the spray gun and the surface to be painted must be set between 150 e i 200 mm (5.9-7.9”).
If the spray gun is working at too low a pressure and at too high a distance, il will not perform to the best of its capacity.
2. The jet from the spray gun must always be perpendicular to the surface being
painted and the paint must be applied in horizontal strokes. Any eventual shift from
this position when spraying will result in an application of the paint layer.