23
WDC200-NX Electronic Water Management.
Revision-2
8 WDC Configuration Systems
8.1 Device
The
Location
string value specifies the location of this device in the WDCMS
network. This value cannot be edited
The WDC device can be connected to an ethernet network. Firstly, the device will
need to establish a connection to the network system. If the
DHCP
setting is
Enabled, the device will obtain an IP address automatically from network DHCP
provider. If
DHCP
is Disabled the device will attempt to connect to the network using
the
IP Address
,
Gateway IP Address
, and
Subnet Mask Address
settings.
Once the device has established a connection to the ethernet network the device will
attempt to connect to the WDCMS server. The
Server IP Address
settings will need
to match that of the WDCMS server to connect.
The WDC device supports Bluetooth connection. The
Bluetooth
setting can be the
following values:
Off
–
The Bluetooth will be disabled
Factory
–
This is used when programming the unit during factory production.
Normal
–
This is for normal operation of the Bluetooth module. Using BLE the WDC
device will advertise itself with the string defined in
Bluetooth Advertise Name
or if
undefined with
“WDC [SERIAL NUMBER]” where [SERIAL NUMBER] is the serial
number of the WDC device.
8.2 Commissioning Purge
The commissioning purge will sequentially run the Cold Tap, Hot Tap, Shower, and
WC. The Taps and Shower will be operated for the time specified in the
Operation
Time
setting and the WC will be operated as many times as specified in the
Operation Count
setting. This can help release any air trapped in the plumbing
system.
The Commissioning Purge can be started from the Quick Functions menu, or using
Input F.
8.3 Time Slots
The control unit can assign periods of the day when outputs are allowed to operate.
The default Schedules setting allows full operation of all outputs over a 24-hour
period (assuming no lockouts are active). Each output can be assigned to a
configurable timeslot and when activated the assigned output will only become active
if within the allowed ‘time slot’.
