Revision 3
16
Product Manual e-Suite Tap
5.3 e-Suite Tap installation
NOTE:
The installation procedure is shown on a vanity top but also applies
when fitting the tap to a basin.
Refer to Figure 3 in conjunction with the installation procedure below:
Install the tap as follows:
1. Remove the rubber washer (item 2) and
½” BSP back nut (item 3) from the tap
tail.
2. Fit the tap/s to the vanity top (ø22mm holes required) and secure with the back
nut.
3. Check that the ø15mm tap connector (item 4) is not contaminated with grit or
debris and has no sharp edges or burrs. Fit the tap connector over the encoder
shaft (check fibre washer is in place).
4. Slide the brass Tectite push fit (item 5) over the encoder shaft and fit onto the
copper end of the tap connector until it fully reaches the stop.
NOTE:
Do not push on the bottom of the assembly! The shaft should protrude
from the bottom of the assembly when installed fully.
5. Fit the lower connector (item 6) into the bottom of the Tectite push fit, as shown
so that the encoder shaft protrudes through the center.
6.
Tighten the anti-rotation grub screw in the lower fitting.
NOTE: The grub screw only needs to be tight enough to prevent rotation of the
lower fitting, DO NOT OVER TIGHTEN.
7.
Install encoder as per instructions in Section 5.5
