Wallgate ALB-01, Product Manual

Page: 17 / 20

Revision 3
17
Product Manual ALB-01, 03 & 05
6. User and Maintenance Instructions
The ALB Bath, Support Frame with Panels, Tap Head and Control Unit are designed
and manufactured from high quality materials. If you install, operate and maintain
them according to the instructions given in this manual, the unit will give reliable,
efficient service. If you need any further information or advice, please contact
Wallgate customer services.
Wallgate offers a comprehensive service package, details of which can be obtained
from our customer service department. A spare parts service is also available.
Any service or repair work must be done by a qualified engineer. During the warranty
period, the service or repair must only be done by a Wallgate engineer or appointed
service agent. Refer to the Wallgate terms and conditions for warranty information.
6.1. Operation
1. The unit is switched ON and OFF using the main isolation switch (provided by
the installer), located near to the electronic Control unit.
NOTE: If a fault occurs with the unit you must set the isolator to the OFF
position until the fault is repaired by a qualified engineer.
WARNING! Risk of electric shock, serious injury and death. Only trained and
qualified personnel should remove the cover of the electronic control box.
2. Operate the cold and hot water nozzles by pressing the piezo touch buttons.
The piezo touch buttons do not have any moving parts. Operate the switch by lightly
pressing the button face with your finger tip. One press of either button, hot or cold,
will allow that water cycle to run for a set time of 180 seconds and then stop. During
a water cycle the water flow can be stopped, by pressing the respective button again.
A new water cycle can be activated once the previous water cycle has been
interrupted or has stopped.
If the cycle time of 180 seconds needs to be changed, detailed information on
settings for adjusting cycle times, limiting the number of cycles, timed lockouts etc.,
refer to Control unit product manual supplied.
The Control unit cannot control temperature of the hot water, this is usually controlled
by a thermostatic mixer valve.
For more information, contact the Wallgate after sales service.