7. Warning!
Be aware of impact and crush hazards
from above. Lower and lock the grapple in
position.
8. Warning!
Risk of falling debris from grapple. Do
not lift any load that cannot be safely
secured by the grapple. Never allow
anyone to walk under overhead load. Keep
bystanders at a safe distance.
9. Caution!
Risk of entanglement in winch line.
Keep hands, loose clothing, and long hair
away from winch line while it is operating.
LXG430RP models only.
10. Caution!
Risk of machine rollover. Do not winch at
angles greater than 25° from centerline of
skid steer.
Use snatch blocks when winching at
angles greater than 25°. LXG430RP
models only.
IMPORTANT! If parts are replaced that have safety signs on
them, new signs must be applied. Safety signs must always
be replaced if they become damaged, are removed, or
become illegible.
Replacement safety decals are available from your authorized
dealer or distributor.
3.3 Replacing Damaged Safety Signs
•
Always replace safety signs that are missing or have
become illegible. Replacement safety signs are available
from your authorized distributor, dealer parts department,
or the factory.
•
Always keep safety signs clean and legible.
•
Parts replaced that had a safety decal on them must also
have the safety sign replaced.
Procedure
Installation area must be clean and dry. Make sure the surface is
free of grease or oil. Ambient temperature must be above 50 °F
(10 °C).
Determine exact position before removing the
backing paper on the decal.
1.
Peel the decal off the backing sheet.
2.
Align the decal with an edge on the machine if possible.
3.
Starting on one edge, carefully press the center of the
exposed sticky backing in place, smoothing it out as you
work from one side to the other.
4.
Use a squeegee, credit card or similar to smooth it out.
Work from one end of the decal to the other end.
Small air pockets can be pierced with a pin and smoothed out
using the piece of sign backing paper.
Safety Signs
LXG400 Series
Log Grapples
Safety
19
