34
BXTR6438
5.3 Starting Procedure
1.
The Wood Chipper should be set up and ready to run.
2.
Set park brake if connected to tow vehicle.
3.
Lower the support leg stand.
4.
Close the choke if the engine is cold.
5.
Move the throttle to its 1/4 throttle position. (If the throttle
is set any higher the centrifugal clutch could potentially
engage and stall a cold engine.)
6.
Use the ignition key and turn it to the
Start
indicator to turn
over the engine. Release the key when the engine starts.
7.
Operate at low idle for a few minutes to allow the engine to
warm.
8.
Gradually open the choke.
9.
Turn the discharge head to its desired position.
10.
Slowly increase the engine speed to engage the rotor drive.
11.
Increase throttle setting to maximum speed for operation.
12.
Ensure that the rotor is up to speed, start feeding material
into hopper.
5.3.1 Stopping:
1.
Stop feeding material into the hopper.
2.
Slow engine to idle.
3.
Turn ignition switch off.
5.3.2 Emergency Stopping
If an emergency occurs:
•
Shut off the engine.
•
Correct emergency situation before restarting engine and
resuming work.
01030
1
2
3
Fig. 11 –
Engine Controls
1. Throttle Lever
2. Choke Lever
3. Ignition Switch
