wallas 88DU, Installation, Operation And Service Instructions

Page: 75 / 284

88DU
Installation
GB
490070GB
Connection to a fi xed tank
If the boat’s fi xed tank is used for the stove, the stove must not be fed through the
same connection as the engine. The stove must have a separate connection as
well as a fuel
fi lter outside the tank. If necessary, the fuel line can be branched off
with a T piece to the Wallas diesel-operated device.
Installation instructions for Tank connection 30011 (accessory)
1. Make a ø 25 mm hole in the upper surface of the fuel tank.
Choose the location of the hole so that when the boat tilts the end of the intake
pipe will stay in the fuel even if the tank is not full. If the end of the intake pipe does
not reach the fuel, the device will quickly choke on the air in the fuel system.
2. Cut the fuel intake pipe (ø 6 mm) to the appropriate length. The end of the pipe
must not touch the bottom of the tank in order to keep water and sediment from the
system. It is recommended to cut the pipe short enough to leave the engine intake
pipe at a lower level. This way the stove cannot empty the tank.
3. Push the cover plug (16) in place.
4. Connect the fuel hose to the heater.
ø 25 mm
Rubber seal press head
Rubber seal
Tightening nut
Intake pipe ø 6/3 mm
Fuel tank
88DU_GB.indd 13 11.06.2008 10:42:39
- 75 -