Before
Line
Indicators
After
Insert bolt
thru square hole
Flip
side extender
Preparing Your
Rear
Mini Wheels for Front Attachment
(This must be done secondly)
If purchasing a Quad Mini Wheelchair, start with instructions in rear box first
1. Remove the rear clamps, leg rings, and front harness from the rear wheelchair.
2. Remove adjustment knob and small washer from the knuckle.
3. Pull out the strut/wheel assembly.
4. Remove both sides of the black round knuckle.
5. Remove the two side extenders and flip them
so that the square hole is lined up with the
knuckle. Attach the knuckle on each side.
(Make sure the line indicators on the side
extenders still face outward on each side.)
(See Diagram 1)
6. Insert the bolt through the middle square
hole on the frame and through the side
extender square hole.
7. Reinstall the knuckle by placing half of it over the bolt. Make sure the arrow is pointing to front of the
wheelchair, teeth on the outside.
8. Attach outside half of knuckle making sure the arrow is pointing upwards, teeth on inside.
9. Insert strut in knuckle at correct height for your dog.
10. Attach washer to bolt then screw on the adjustment knob and tighten.
Note
:
You won’t be using the front harness that came with the rear kit. Instead you will use the Leg Rings that
came with the front wheel kit.
On top of the caster wheels you will see the letter ”
R
” or “
L
”. The “
R
” is for the dog’s right leg, and the “
L
” is
for the dog’s left leg.
Please watch instructional video here:
hpets.net/mfwa
Diagram 2
2
Knuckle
Knuckle
Adjustable
knob
Flat
washer
Strut wheel
assembly
The knuckles come bonded together
for proper angle setting
Strut wheel
assembly
Bolts
Installing the
FRONT
Wheels to the Frame
(see Diagram 2)
Diagram 1