Operating Instructions
24
Parking Brake
The parking brake functions by locking a detent arm
internally into the transaxle. Moving the lever
FOR-
WARD engages
the parking brake; moving the lever
BACKWARD releases
the brake.
IMPORTANT:
Stop the tractor completely before
engaging the parking brake. The parking brake uses
a positive mechanical lock similar to the
PARK
posi-
tion on an automotive automatic transmission. If the
tractor is moving when the brake is engaged, it will
result in sudden stoppage and possible internal
damage to the transaxle.
NOTE:
If pressure on the parking brake pin (e.g.
parked on a hill) makes it impossible to release the
parking brake with the parking brake lever, move the
mower gently forward or backward to allow the brake
detent to release.
Transaxle Lockout Rods
The transaxle lockout rods disengage the transax-
les. By lifting the rods up and locking them into place
with the shoulder on the rod in the chassis notch, the
transaxles are released to permit freewheeling. By
releasing the rods and recessing them back toward
the chassis, the transaxles are engaged for normal
operation. The transaxle rods in the
LOCKOUT
position are used to enable moving the machine
without the engine running (e.g., for service). Refer
to
TRANSAXLE LOCKOUTS
in this section for
operating instructions.
NOTE:
The transaxle lockout rods ends should be
completely retracted against the chassis, otherwise
operation of the transaxle may be erratic.
Hydro Lockout Rod Location
Hourmeter
The hourmeter, which is located on the right front of
the body, displays
operating time
accumulated
while the ignition switch is in the
ON
position.
The hourmeter provides maintenance reminders
after certain hours of operation. The hourmeter
screen will start flashing the reminder one hour prior
to the recommended interval and will continue until
one hour after the recommended interval (two
hours). The hourmeter
does not have a manual
reset function.
*
These intervals reflect the actual time that the
reminder will flash (one hour prior to and one
hour after the recommended interval).
**
This reminder is only used one time.
*** In normal operating conditions, oil changes in
100-hour intervals are acceptable. Walker and
the engine manufacturers recommend engine
oil changes every 50 hours in extremely dirty
or dusty conditions or for units with less than
100 hours annual use.
NOTE:
The blinking hour glass on the display
means that the meter is operating properly.
Hourmeter
Hydro Lockout
Rods
Procedure
Interval*
Reminder
Oil Change
(Break-In)**
4-6 Hours
C
H
G
OIL
Lubricate
and Check
Levels
24-26 Hours
LUBE
Oil Change
49-51 Hours***
C
H
G
OIL
