4
WARNING
Danger of crashing, entrapment and fire through the falling down of the device
The weight of the device is approx. 0,5kg.
−
Make sure, that the device is always positioned tilt and skid resistant and stored securely.
−
Avoid placing cables where they can be tripped over. The device could be overturned.
WARNING
Danger of electric shock, burn hazard
Please note, that the device is still connected with the supply voltage even if it is switched off. Just
after disconnecting the device from the power supply through pulling out the power cable, the
device is actually de-energized.
−
Switch off your device when it is not in use.
−
Switch off your device before mounting and maintenance and disconnect from power supply.
−
Protect your device against unintended switching-on.
−
Unplug the power cord, if the flash is not in use for a long time.
WARNING
Danger of electric shock, fire through short-circuit
A short-circuit could be caused through defect cables and through humidity or moisture. A short-
circuit can warm up the conductors, so that there isolation will melt or even melt thoroughly. This
could lead to fire.
−
Please just use the original cables, which are included in delivery. They are aligned for your
device and guarantee the necessary safety for you and your device.
−
Don´t operate the device with wet hand or feet.
−
Operate the device only in dry rooms.
−
Don´t operate the device outdoors.
−
Please only follow this instruction manual for cleaning the device.
−
Make sure, that cables and conductors won´t be damaged. Damages could be caused through
heat impact, chemical influence or through mechanical impacts as rubbing, bending, tearing,
rolling over or nibbling animals.
−
Prevent your device for falling-off.
In case of falling-off, please let an electrician check the device before switching on again.
−
If your device should be damaged or defect or if you notice a burning smell:
Disconnect the power supply by pulling out the power cord immediately. Never operate your
device with damaged housing, defect lamps or damaged power cord. Don´t open the device.
Never repair the device on your own. The device should only be repaired by electricians.
−
Please follow this instruction manual for maintaining your device.
−
Please just use spare parts, which are conform to the required specifications.
See
Technical Specifications
.
WARNING
Fire danger through overheating
The accessories can overheat, if it does not comply with the necessary specifications. The device
itself, accessories and easily inflammable materials in close distance could catch fire.
−
Please just use accessories and spare parts, which are conform to the required specifications.
See
Technical Specifications
.
−
Lamps, which are damaged or deformed through heat, should be exchanged immediately.
−
Remove easily inflammable materials, which are in close distance to the device.
CAUTION
Danger of burning on hot parts
The lamps could heat up up to 85 °C, the housing up to 50 °C.