30
31
NOTE
Compare the local electric power supply with the connection values of
the device. Should the connection values not match, please contact
• Only connect the device to an earthed socket
NOTE
After use disconnect the device from the local power supply by simply pulling out
the mains plug.
7. Instructions for use and recommendations
7.1 Starting up and displays
Turn the right button of the brightness adjuster in an anti-clockwise direction,
completely to the left, against the slight resistance, until „OFF“ is reached. The
light is switched „ON“ and „OFF“ using the right control dial which is for the
brightness level.
7.2 You can now connect the mains cable or the battery/batteries. Please switch off
the device when changing the battery of connecting the mains cable.
7.2.1 Use with battery:
Place a sufficiently charged and compatible battery (see detailed instructions
for your model on pages 20 to 22) on the rear of the video light into the battery
compartment. Usually, a short clicking sound from the battery safety lock indi-
cates that the battery has been correctly inserted.
7.2.2 Use with a mains cable
Plug the mains cable of the device into the round socket of the video light and
then the mains cable into the electric power supply socket.
7.2.3 The video light is now ready for use
7.3 Turn the right brightness adjuster knob clockwise and the LED light will come on.
• The brightness can be adjusted in increments of 1% from 10 to 100%, and the
level will be shown at the top of the display in the area marked <Dimmer>.
• At the bottom of the display, in the <colour> field, the colour temperature will
be indicated in Kelvin (e.g. 5,600K). For daylight models, this is set at 5,600K
(daylight level).
• For bi-colour models, the colour temperature can also be set using the left
control dial in steps of 100 Kelvin from 3,200 to 5,600 K.
WARNING
With any action you take you should pay attention to the safety notes in
the corresponding paragraphs.
• Charge process
• Use with power supply unit
• Mount the unit on a tripod (optional).
• Adjust the inclination angle.
• Connect the device to the electric power supply.
• Switch the unit on / off - dimmer function
6. Charging batteries
• Insert the round battery charger plug into the charger socket.
• Only connect the device to an earthed socket.
• The battery display LEDs will light up shortly after inserting 1 or 2 batteries
(depending on model) to show the current charge level.
• If the batteries are not fully charged, the charger will automatically start to
charge after a short time.
• During charging, the LED diodes will flash, showing that charging is taking
place and the level of charge that has been reached.
• As soon as the battery or batteries has/have been charged, the LEDs will re-
main lit. The charging process has ended and we recommend that you remove
the batteries.
NOTE
In order to ensure the longevity of the power pack you must charge the power
pack to full capacity before using the video light for the first time. Use the power
pack until it is completely discharged. Then recharge the power pack to full
capacity. Repeat these steps about 2 times.