Waldorf M, User Manual

Page: 55 / 91

Sound Parameters
55 M Manual
r
If Loop Start point is < than the Key Off point , the
loop will be at sustain phase. If the Loop point is >
than Keyoff, the loop will be at release phase. If Loop
Start point = Key off point, there will be no loop.
LOOP
Selects whether a loop is performed in the Wave envelo-
pe’s or not.
Free Env Display Page (for Free envelope)
Most display pages for the Free envelope are identical to
the Wave display pages, except the Loop page:
LOOP
Selects whether a loop is performed in the Free envelope’s
release phase or not. If set to
on , a loop is always between
point 0 and sustain, when a key is pressed. If
REL.LOOP
is
not active, it goes to the release level after a key is relea-
sed, according to the setting of Release time. If
REL.LOOP
is active, the envelope will also loop between point 1 and 3
(i.e. sustain point) AFTER passing the release phase. If you
use the same level for release as for sustain and the release
time is set to
0 , it will be loop always, if both
LOOP
options
are active.
REL.LOOP
Defines, if a loop on the release phase is active or not. The
loop on release phase runs always between 1 and 3
(sustain point) as on the note active phases, but it also will
pass through release phase (if Release Time > 0).
ENV Tweaks Display Page
This display page is valid for all 4 envelopes.
T/L MODE
Determiness the calculation mode inside the DSP, how the
Time or Level modulations of all 4 envelopes are applied to
the parameter.
In MW Mode, all works as on the classic Microwave :
Modulated value = settings value + settings value * modu-
lator * amount. Hence, if the setting value is subtle, a mo-
dulation will also be subtle, and if it's 0 - there will be NO
modulation.
In M mode, it works in a different way :
Modulated value = settings Value + modulator * amount,
i.e. the setting value does not affect the modulators pro-
duct, hence a modulation is independent of the original
parameter value, and if it's
0 , it still can be modulated.