29
Controller Advanced Programming Mode
Programming the ‘Melt Cycle’.
1.
One of the following 3 options may be selected:-
‘L’ (Liquid).
‘S’ (Solid).
‘O’ (Override).
2.
To change the programmed ‘Melt Cycle’, press either
‘Timer 1’ or ‘Timer 3’ key to scroll through the three
options.
3.
Once the desired option is selected, press Program Key
‘P’ to accept the change, display will step on to
‘Setting
the Temperature Units’
.
Setting the ‘Temperature Units’.
1.
User may select from ‘F’ (Fahrenheit) or ‘C’ (Celsius).
2.
Press either ‘Timer 1’ or ‘Timer 3’ key to change
selection.
3.
Press Programme Key ‘P’, the change will be accepted
and display will revert to
‘Idle Mode’
.
NOTE:
Pressing and holding Programme Key ‘P’ for approximately 3 seconds (Or not pressing
any keys for 2 minutes) during Advanced Programming Mode, the appliance will exit
Advanced Programming Mode and return to Idle Mode.
System Programmable Default Settings
The table below shows a list of the programmable parameters and the default settings for this appliance.
These settings can be edited from the Control Panel when in either
‘Controller Basic Programme Mode’
or
‘Controller Advanced Programming Mode’
.
Programmable Default Settings
Controller Basic Programming Mode
Default Settings
Timer 1 ‘L’ Cook Time
3:00 min.
Timer 2 'Ctr’ Cook Time
3:00 min.
Timer 3 'R’ Cook Time
3:00 min.
Temperature Set Point
177°C (350°F).
Keypad Lock or Unlock
Unlock.
Controller Advanced Programming Mode
Default Settings
Timing Mode
S.t (Straight).
Temperature Offset
0°.
Temperature Display Mode
t. -0 = 'HEAt' or 'droP'.
Melt Cycle Mode
L (Liquid).
Degrees; °F or °C
°C.
Summary of Contents for FN8120GE
Page 37: ......
