WARNING! MAKE CERTAIN THAT THE MACHINE IS DISCONNECTED FROM THE POWER
SOURCE.
ATTACHING DEPTH ADJUSTMENT CRANK HANDLE
Attach the raise/lower adjustment handle to the shaft located on top of the planer and fasten in place
with 1 Hex Socket Head screw M5*25, Tighten screw using supplied hex wrench.
Facing the rear of the machine, place the outfeed table in the down position.
Attach the dust on the cutterhead assembly using 4 of the plastic star knob screws making sure the
4” port is facing at an upward angle.
ATTACHING DUST PORT
1.
2.
NOTE: When operating the planer, we recommend using full size dust collector with a 4” hose, or a
good sized shop vacuum with a cyclone type collection device installed between the planer and the
shop vac using the 2 1 / 2” supplied adapter.
12
