Adapter C
12x142mm Configuration
(Adapter D)
12x148mm Configuration
(Adapter D)
FOR 142MM OR 148MM THRU AXLE
Adapters Needed: C and D
To be used with the 12mm thru
axle supplied with bicycle.
SCALE 0.500
SCALE 0.500
(1)
(2)
ATTACHING YOUR BICYCLE
Shift your bicycle chain into the smallest sprocket in the front and rear, then remove
your rear wheel. Install your bicycle on the KICKR by aligning the chain with the
smallest sprocket on the KICKR and pressing down to fully seat the dropouts on the
KICKR’s axle.
For bicycles with quick release -
Secure your
bicycle by tightening the quick release acorn
nut and clamping the quick release lever shut.
The quick release lever is “open” when it curves
away from the bicycle frame (1); the lever is
“closed” when it curves towards the bicycle
frame (2). The handle of the quick release skewer is always on the non-drive (non cassette)
side of the KICKR. Only use the provided quick release skewer while using the KICKR.
For bicycles with thru axle -
Secure your bicycle by reinstalling
your bicycle’s thru axle (3) and
tightening to manufacturer
specifications (4).
CAUTION! Failure to properly tighten the quick release skewer or thru axle may result
in property damage or personal injury. If you are unsure of the proper tension, please
consult your local bike shop or contact Wahoo Fitness for assistance. Do NOT ride the
KICKR until the quick release skewer or thru axle is tightened.
PROTIP: Lift the front wheel up while pressing down on the saddle to ensure
the bicycle is fully seated on the trainer.
P
(3)
(4)
Adapter A
130mm Configuration (Adapter B)
135mm Configuration (Adapter B)
FOR 130MM OR 135MM QUICK RELEASE
Adapters Needed: A and B
KICKR comes pre-configured out of the box for bicycles with 130mm quick release
spacing. If you have a bicycle with 130mm spacing proceed to “Attaching your Bicycle”.
For 135mm spacing, remove quick release skewer, reverse Adapter B and reinstall
quick release skewer.
ENGLISH
